PxConvexFlag

Defined in include/cooking/PxConvexMeshDesc.h

struct PxConvexFlag

Flags which describe the format and behavior of a convex mesh.

Public Types

enum Enum

Values:

enumerator e16_BIT_INDICES

Denotes the use of 16-bit vertex indices in PxConvexMeshDesc::triangles or PxConvexMeshDesc::polygons.

(otherwise, 32-bit indices are assumed)

See also

PxConvexMeshDesc.indices

enumerator eCOMPUTE_CONVEX

Automatically recomputes the hull from the vertices.

If this flag is not set, you must provide the entire geometry manually.

See also

PxConvexMeshCookingType

Note

For the specific algorithm used in hull computation, please see PxConvexMeshCookingType.

enumerator eCHECK_ZERO_AREA_TRIANGLES

Checks and removes almost zero-area triangles during convex hull computation.

The rejected area size is specified in PxCookingParams::areaTestEpsilon

Note

This flag is only used in combination with eCOMPUTE_CONVEX.

enumerator eQUANTIZE_INPUT: Quantizes the input vertices using the k-means clustering.

Note

The input vertices are quantized to PxConvexMeshDesc::quantizedCount see http://en.wikipedia.org/wiki/K-means_clustering

enumerator eDISABLE_MESH_VALIDATION

Disables the convex mesh validation to speed-up hull creation.

Please use separate validation function in checked/debug builds. Creating a convex mesh with invalid input data without prior validation may result in undefined behavior.

See also

PxCooking::validateConvexMesh

enumerator ePLANE_SHIFTING

Enables plane shifting vertex limit algorithm.

Plane shifting is an alternative algorithm for the case when the computed hull has more vertices than the specified vertex limit.

The default algorithm computes the full hull, and an OBB around the input vertices. This OBB is then sliced with the hull planes until the vertex limit is reached.The default algorithm requires the vertex limit to be set to at least 8, and typically produces results that are much better quality than are produced by plane shifting.

When plane shifting is enabled, the hull computation stops when vertex limit is reached. The hull planes are then shifted to contain all input vertices, and the new plane intersection points are then used to generate the final hull with the given vertex limit.Plane shifting may produce sharp edges to vertices very far away from the input cloud, and does not guarantee that all input vertices are inside the resulting hull.However, it can be used with a vertex limit as low as 4.

enumerator eFAST_INERTIA_COMPUTATION: Inertia tensor computation is faster using SIMD code, but the precision is lower, which may result in incorrect inertia for very thin hulls.

enumerator eGPU_COMPATIBLE

Convex hulls are created with respect to GPU simulation limitations.

Vertex limit and polygon limit is set to 64 and vertex limit per face is internally set to 32.

Deprecated:: since PhysX 5.2. Setting PxCookingParams::buildGPUData to true always cooks GPU-compatible meshes.

Note

Can be used only with eCOMPUTE_CONVEX flag.

enumerator eSHIFT_VERTICES

Convex hull input vertices are shifted to be around origin to provide better computation stability.

It is recommended to provide input vertices around the origin, otherwise use this flag to improve numerical stability.

Note

Is used only with eCOMPUTE_CONVEX flag.